A client came to THE LAB at Ambrell with an application that involved removing urethane from a steel insert (doffer pad). THE LAB determined that an Ambrell EASYHEAT^TM 10 kW, 150-400 kHz solid state induction heating power supply would work well for this debonding application along with a workhead and coil specifically designed for this application. The assembly needed to be heated to 800 ºF (427 ºC) with the frequency set to 207 kHz.

A client contacted THE LAB at Ambrell needing to heat aluminum molding to activate an adhesive coating prior to applying the vinyl. The target temperature for the application was 500 ºF (260 ºC). THE LAB determined that an Ambrell EKOHEAT^® 20 kW power supply with a specially designed 14-turn helical coil would be the right solution for the client's requirements. 

A client needed to heat the stainless-steel substrate of a solar panel shingle in order to melt the polymer encapsulant, allowing two shingles to bond together. THE LAB at Ambrell determined that an Ambrell EASYHEAT^TM 1.2 kW, 150-400 kHz solid state induction heating power supply would work well for this bonding application along with a workhead and coil specifically designed for this application. The assembly needed to be heated to 266 ºF (130 ºC).

A client came to THE LAB at Ambrell with an application that involved separating bonded stainless steel/carbon fiber assemblies by heating tang, which softens the adhesive bond. THE LAB at Ambrell determined that an Ambrell EASYHEAT^TM 2 kW, 150-400 kHz solid state induction heating power supply would work well for this debonding application along with a workhead and coil specifically designed for this application. The assembly needed to be heated to 300 ºF (149 ºC) at 200 kHz.