Heating Catheter Tipping Die
Molding a teflon catheter tip
Notre bibliothèque de notes d'application gratuites embouts de cathéters.
Sélectionnez la note qui vous intéresse pour en savoir plus.
Fuse thermoplastic catheter tubes
Heating of the mandrel is from the inside out providing a smooth finish on the outside of the assemblies.
To heat an aluminum catheter tipping die to above 285 °F within 2 to 5 seconds for the forming of catheter material.
Heating a catheter tipping die
A two turn plate concentrator coil is used to heat the die. To measure the temperature on the ID and establish the time-to-temperature relationship...
Heat a water-cooled steel mandrel to 700 °F (371 °C) to form a high quality Teflon catheter tip.
Plastic Reflow With Catheter Tubing
Heat a metal braid in a plastic catheter tube to 250 °F (121.1 °C) so that another catheter tube can be bonded to it.
AMBRELL CORPORATION
1655 Lyell Avenue
Rochester, NY 14606
United States
Directions
T: +1 585 889 9000
F: +1 585 889 4030
Contacter le Service Commercial
Contacter le Service des Commandes
Contacter le Service
AMBRELL B.V.
Holtersweg 1
7556 BS Hengelo
The Netherlands
Instructions
T: +31 880 150 100
F: +31 546 788 154
Contacter le Service Commercial
Contacter le Service des Commandes
Contacter le Service
AMBRELL Ltd.
148-149 Gt Charles Street
Birmingham, GL51 9FL
United Kingdom
T: +44 1242 514042
F: +31 546 788 154
Contacter le Service Commercial
Contacter le Service des Commandes
Contacter le Service