Induction Soldering a Vent Tube Assembly
THE LAB at Ambrell tested an induction soldering application involving heating both ends of a customer's copper float assembly. The client had been...
After a busy week at FABTECH Mexico, we were delighted to open THE LAB in Monterrey Mexico. Induction heating parts testing for customers in Mexico and Latin America will take place at this new facility. To commemorate the occasion, a special ribbon cutting and open house event was held. Tours were given, demonstrations were shown, and food was served. Here are a few photos from the event:
.jpg?width=740&height=415&name=MicrosoftTeams-image%20(6).jpg)
-800.png?width=740&name=MicrosoftTeams-image%20(7)-800.png)
To learn more about our application laboratory/parts testing service, visit our website.
Induction Shrink Fitting: Copper Ring into an Aluminum Casting
Objective Shrink fitting is a mechanical joining process that creates an extremely tight, permanent joint by intentionally making an outer part...
Induction Brazing a Threaded Bulkhead Fitting
Induction Application Objective Brazing threaded bulkhead fittings can be a challenging process—especially when consistency, joint integrity, and...