THE LAB at Ambrell tested an induction heating application involving soldering a brass end cap onto a heat exchanger. An Ambrell EASYHEATTM 10 kW, 150-400 kHz induction heating system equipped with a remote workhead and a dual four-turn pancake coil specifically designed for this application was determined to be the right solution for this soldering application. The system frequency was set to 237 kHz.
Induction Soldering a Brass End Cap onto a Heat Exchanger
Sep 1, 2020 4:27:55 PM / by Brett Daly posted in Soldering, THE LAB, induction soldering
Induction Soldering Fabric to a Kovar Tip Assembly
Jul 31, 2020 11:41:15 AM / by Brett Daly posted in Soldering, THE LAB, induction soldering
THE LAB at Ambrell tested an induction heating application involving soldering fabric to a Kovar tip assembly. An Ambrell EASYHEATTM 1.2 kW, 150-400 kHz induction heating system equipped with a remote workhead and three-turn pancake coil specifically designed for this application was determined to be the right solution for this soldering application. The target temperature was 300 ºF (149 ºC) and the system frequency was set to 242 kHz.
Induction Soldering Applications Brochure Now Available
Jun 26, 2020 3:11:09 PM / by Brett Daly posted in Soldering, induction soldering
A new brochure that highlights induction soldering applications is now available. This brochure, which is titled "Improved Soldering with Induction Heating," reviews ten soldering applications that were tested by THE LAB at Ambrell. It also discusses what soldering is and why induction is often a good choice for soldering applications.
Reflowing the Solder on a Circuit Board
Apr 13, 2020 4:17:15 PM / by Brett Daly posted in Soldering, THE LAB
THE LAB at Ambrell tested an induction heating application involving heating a solder joint to reflow the solder on a circuit board evenly. The end product was a diesel fuel tank component. The target temperature for the application was 482º F (250º C) and THE LAB determined that an EASYHEAT™ 10 kW, 150-400 kHz induction heating power supply was the right solution for this soldering application.