Ambrell Induction Heating
Ambrell Induction Heating
heating a steel plate

Brett Daly


Recent Posts

Brazing Brass and Copper Aerospace Samples

Aug 30, 2019 1:41:28 PM / by Brett Daly posted in Induction Brazing, brazing

 

A client in the aerospace industry needed to braze brass and copper nozzles. They had been using a torch, but were looking for a cleaner and more repeatable heating solution. So they sent their parts into THE LAB at Ambrell for complimentary parts testing to see if induction might be a better heating solution for their brazing application. 


Read More

 


Heating Hammer Bits for Shrink Fitting

Aug 29, 2019 4:21:59 PM / by Brett Daly posted in Shrink Fitting, induction shrink fitting

 

A client in the oil and gas industry came to Ambrell with a shrink fitting application. They had been using a cold method for inserting carbide buttons into hammer bits, but wanted to look to induction heating. They took advantage of THE LAB at Ambrell's complimentary applications testing to determine the feasibility of their shrink fitting application. 

Read More

 


Ambrell to Exhibit at the Electric and Hybrid Vehicle Technology Expo

Aug 19, 2019 10:41:15 AM / by Brett Daly posted in automotive, Trade Shows

 

Ambrell, an inTEST Company and a leading manufacturer of induction heating solutions, will again exhibit at the Electric and Hybrid Vehicle Technology Expo at the Suburban Collection Showplace in Novi, MI USA. The event will take place September 10-12 and representatives will be on-hand in booth 1023. We'll have an EASYHEAT induction heating system on display and an applications engineer from THE LAB will be available to discuss attendee applications. 

Read More

 


The Induction Heat Staking Design Guide

Aug 1, 2019 3:52:42 PM / by Brett Daly posted in Metal-to-Plastic, heat staking, heat staking with induction

Our newly updated design guide, titled the Heat Staking Design Guide: Inserting Metal into Plastic with Induction by Dr. Girish Dahake, is now available for download. Heat staking of threaded metal inserts into plastic (also known as metal-to-plastic insertion) is a common induction heating application, and this design guide will help you get started. With heat staking, the insert is preheated with induction and then pressed into a hole in the plastic part. This is accomplished by positioning the induction coil over the hole and then holding the insert in the coil for a short period of time. When the correct temperature is achieved, the insert is pressed into the plastic.

Read More

 


SUBSCRIBE

Applications & Industry News

See More